Results 1 to 8 of 8
Threaded View
-
12-20-2019, 10:32 PM #5
- Join Date
- Dec 2019
- Posts
- 3
I'm using CURA 4.4. I was actually able to nearly eliminate this by tightening the y axis belt beyond what I normally would do. I'm still seeing a very slight almost imperceptible shadow of the issue but I was able to reprint the Eiffel tower that I showed in the picture and I happy. Is it possible this really was a belt problem that only affected those layer on just those faces? the back of the cubes I showed look good.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion