Results 1 to 1 of 1
-
10-02-2019, 11:10 PM #1
- Join Date
- Sep 2019
- Posts
- 2
Please help with my terrible Benchy!
I've tried printing Benchy three times, each one terrible. Before benchy, I've done many simpler prints with mixed results.
I'm using a Qidi X-Pro with 1.75mm GEEETECH PLA. I'm using Qidi Print for the slicer. I've had the printer for about two weeks.
I've tried:
(all prints .2mm layer height, bed leveled before each print, no prime towers or ooze shields-- trying to avoid using these if possible)
1.
200C & 60C bed
15% infill/zigzag
50mm/s print speed, 80mm/s travel speed,
3mm&30mm/s retraction, retract at layer change
.1mm^3 coasting,
100% extrusion,
0mm z offset, no travel prime
no z hop
2.
210C & 50C bed
15% infill/zigzag
50mm/s print speed, 100mm/s travel speed
5mm&35mm/s retraction, retract at layer change
.1mm^3 coasting
100% extrusion
0mm z offset, no travel prime
no z hop
3.
195C & 60C bed
20% infill/zigzag
50mm/s print speed, 80mm/s travel speed
3mm&30mm/s retraction, retract at layer change
.1mm^3 coasting
90% extrusion
0mm z offset, no travel prime
1mm z hop, z hop when retracted, z hop after extruder switch
crappybenchy.jpg
Any tips or advice would be greatly appreciated. Thanks for taking a look!
-Blake
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help