Results 1 to 10 of 10
Threaded View
-
02-04-2019, 03:32 PM #9
- Join Date
- Aug 2015
- Posts
- 256
If you insulated your chamber well, the heated bed is all the heater you may need. My chamber for my CR-10S stays between 45 and 50C with the bed temp set at 100C.But I like to reduce all variables so I use an Inkbird temp controller which I hook up to a hair dryer (warm) and a small vent fan (cool), this maintains the temperature within a few degrees no matter what the room temp (it's an unheated shop).
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help