Close



Results 1 to 7 of 7
  1. #1

    How much would it cost to print a figure?

    Hey, I am new here!
    I have a couple of questions.
    How much would it cost to get a 3d printer which could print this figure in a good quality?
    And how much approximately would it cost to print the figure 10 cm long or 20 cm long if I bought a printer?

    https://ae01.alicdn.com/kf/HTB10TvKR...pg_640x640.jpg

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,801
    depending on the printer the material to print could be anything from a 50 cents on up to a few dollars.
    for the 20cm print start thibnking around $4-500 and a resin based machine.

    For the 10 cm, you'd still be better off with resin - from aquality point of view, so similiar price :-)

    If you want to stick with fdm - then a dual nozzle system for soluble supports would be a good idea.

  3. #3
    Engineer-in-Training
    Join Date
    Aug 2015
    Posts
    256
    For a resin print, a 10cm print could cost between a $1 to $10, depending on how well you hollowed it out well before printing, how thin the walls were, and how much support you used.

    A hollow 20cm print with the same wall thickness would cost about 4 times as much as the 10cm print.

  4. #4
    3D printing will not cost you more. It depends on what you are printing and which material you are using to print.

  5. #5
    Technician
    Join Date
    Dec 2018
    Posts
    62
    The cost will depend on which type of 3D printer you want, what is your requirements and what type of material you want to use.

  6. #6
    Engineer ralphzoontjens's Avatar
    Join Date
    Nov 2013
    Location
    Tilburg, the Netherlands
    Posts
    533
    Follow ralphzoontjens On Twitter Add ralphzoontjens on Facebook Add ralphzoontjens on Shapeways Add ralphzoontjens on Thingiverse
    You can get a Wanhao D7 for under $500 and it has a build volume of 120x68x200mm.

    Now for a 10cm figure I estimate it will cost $3 including support material, a 20cm figure $15.

  7. #7
    Hello,Another option is a Photon Anycubic DLP printer, i get one some months ago and I am happy with it.

    Best regards!


    ➤ Blog/Forum: https://3d-work.es
    ➤ FaceBook: https://www.fb.com/3DWork.Spain
    ➤ Thingiverse: https://www.thingiverse.com/3D_Work

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •