8"
J-Head Mk IV-B Hot End for 3mm filament
Slic3r 1.0.0 RC3
PLA 3mm
2 medium coats of Super Hold Aquanet. Spray it once then immediately do a second coat. Let dry for 10 min.
Print at 205C with a 60C heated bed

Measure your filament and set it in your slicer. 3mm != 3mm. In Slic3r, Filament settings tab, Filament, Diameter = I am printing 2.85mm right now.

When printing would end my bed was stuck at 60C. To have the bed shutoff after the print do the following in Slic3r.
goto Printer Settings tab, Custom G-Code, End G-Code then add the following line to the top of the End G-Code
M140 S0 ; turn off bed heater