Results 1 to 5 of 5
Thread: Supports not sticking to bed
Threaded View
-
11-09-2018, 05:25 PM #2
- Join Date
- May 2018
- Posts
- 566
I will use a brim when I have support on the bed that are only a few (not much contact area) I also set solid layers to 5 or 6 (S3D) so that you get full layers at the bottom. Kapton (polymide) tape is what I use on my glass, very little issue with things not sticking, more often can't get them off..
Good luck
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help