Results 1 to 3 of 3
Thread: CR-10 Possible underextrusion?
-
10-15-2017, 12:22 AM #1
- Join Date
- Oct 2017
- Posts
- 1
CR-10 Possible underextrusion?
Hi everyone,
I recently bought a CR-10, and I decided to print a Benchy at 0.05 mm layer height with 15% infill. I noticed that there are holes/gaps in the support (as shown in the picture below). I thought this could have been underextrusion, but the other areas printed flawlessly. I am also pretty sure that the top layer didn't fill in completely since I only used 2 perimeters. I used Craftware to slice this. Could anyone help me with a possible reason as to why there are gaps in the support?
printer1.jpg
printer 2.jpg
printer 3.jpg
Thanks,
Protolate
-
07-25-2018, 11:23 AM #2
- Join Date
- Oct 2017
- Posts
- 4
Old thread, but incase you never found what was causing this, it's usually too fast printing speed.
-
07-27-2018, 07:33 PM #3
- Join Date
- Jul 2018
- Posts
- 10
ProtolateTry slowing your print down while it is printing. Turn the knob to reduce F/R on the control box.John
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion