Results 1 to 1 of 1
-
04-26-2018, 01:00 PM #1
- Join Date
- Apr 2018
- Posts
- 2
Need troubleshooting help! Makerbot Replicator (5th gen) Smart Extruder +
Hi 3D Printing Community!
I have a call to action for you: The office 3D printer is not printing as it should/as it used to. I have run out of basic troubleshooting options and am not sure how to proceed in a way that will help diagnose the problem. How should I troubleshooting from here?
Efforts:
- Callibrated the build plate with assisted leveling
- Changed the extruder head
- Re exported a new .makerbot file
- Reset printer to factory settings
- Changed the filament
- Checked the belt tightness
- Adjusted the temperature settings
Aside from the temperature setting, all of the prints were sliced at default medium-resolution settings.
Furthest left Benchie was printed a couple months ago when I started using the printer. This week the printer started acting up and I have been printing a lot of benchies. The middle one is how most of them are printing. Furthest right is the worst so far (got it from raising the temperature setting).
1.jpg2.jpg6.jpg7.jpg5.jpg
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion