Results 1 to 4 of 4
Thread: Help a newb!
Threaded View
-
04-14-2018, 03:11 PM #2
- Join Date
- Apr 2016
- Posts
- 120
You need to reset the bed height, as it needs to squish the 1st layer down a bit more. Slow the speed down by about 30% and check the print settings in S3D. You may be changing the settings on the wrong extruder.
Mine always does a purge line before printing. This primes the head and stops the string of material being dragged across the bed.
Try heating the bed a little.
I use Buildtak as the print surface. It works with every material I've tried and is long lived as well - certainly more than 100 prints per surface with care.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help