So, we were on the fence about buying a Fusion 3 or theFormLabs Form 2 resin printer. We have pieces printed in Form 2 that are prettysolid. Basically we have the infill cranked up as high as it will go, and itgive us very dense pieces (similar to machined) with FormLabs ABS-like resin.Is the layer bonding issue specific to filament printers, or can you get alevel of density that you would get from a resin printer with the Fusion 3? Weinevitably went with the Fusion 3 because you could print in things like nylon,ABS, and polycarbonate, and they stated that the relevant strength moduli werecomparable to cast versions of these plastics. Is this claim misleading?