Results 1 to 3 of 3
-
02-05-2018, 11:22 AM #1
- Join Date
- Feb 2017
- Posts
- 79
Small blobs/stringing while traveling, is this a retraction setting issue? +PIC
I don't think I see this that often but I did notice it on this print. I was able to pull it off as it wasn't adhered but the blobbing between the stringing has me confused. I'm using maker select w/ 1.75 PLA at 205. Retraction is at 4mm @40mm/sec. I took this directly from the maker select (Wanhao duplicator i3) specific cura so I would assume it would be accurate but who really knows? Travel speed is 150mm/sec.
Thanks much,
Dave
-
02-06-2018, 11:05 PM #2
- Join Date
- Feb 2017
- Posts
- 79
Anyone have an opinion?
-
02-07-2018, 06:00 AM #3
Enable Retraction, and maybe Z Hop when retracting.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help