Results 1 to 9 of 9
Threaded View
-
01-07-2018, 12:38 PM #3
- Join Date
- Feb 2017
- Posts
- 79
Robert that is what i thought as well. I went ahead and pulled it back a hair last night (Lowered bed) and it is better, still sticks quite a bit but 100% better. i may try to lower the bed a few thousandths more to see what I get but i'm pretty happy w/ the initial later print width. I would rather have great adhesion than the alternative. Maybe when I run out of this blue tape I'll try the vinyl transfer paper. The good thing about the strips of tape is that when I nick one or when the print pulls up the tape I just have to replace a strip.
Dave
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion