Results 1 to 10 of 25
Thread: Garbled LCD screens
Threaded View
-
01-03-2018, 03:15 AM #21
- Join Date
- Jan 2018
- Posts
- 1
Printbus and ESS, I cannot say thanks enough to you both. I had already shielded the LCD ribbon of my ANET A8 but the screen still failed once every 3 min or so. I then installed only one 47 Ohm resistor directly on the LCD PCB in serial of the ENABLE signal and combined with the shielding connected to ground, it's now working very very well.
I have not yet the feedback over a long print but definitely it helps a lot.
But ENABLE+47Ohm alone or shielding alone is not enough (for me)
ANET_LCD_solution.jpg
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help