Results 1 to 6 of 6
Threaded View
-
12-22-2017, 01:49 PM #5
Hot diggity !
Clean sharp print at 50mm/s - to be fair I am just printing a flat shape, but even so .
I've gone from printing these in 2 colours that took over 3 hours, to a stronger, better, one colour design that takes 30 minutes :-)
Oh yeah and this prints on a cold bed with the first layer at 100% speed.
60mm/s looking quite good too :-)
Going to try some filaflex next. Never had any luck with it on the rep clones before.
***
Hot diggity indeed !
Currently printing filaflex at 50mm/s 230c, unheated bed.
Looking good !
So for the sake of a piece of ptfe tubing that costs a few cents, the basic rep clone extruder can be turned into a flexible printing superstar :-)
Should have done this years ago !
Guess the next job is to do the same mod on the Knp.
Maybe after christmas lol
The weird thing is I haven't moved from my chair and I've lost the third one I did at 60mm/s with a slightly varied design. Just vanished.Last edited by curious aardvark; 12-22-2017 at 03:03 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion