Results 1 to 6 of 6
Thread: Prints coming out terrible
-
12-12-2017, 08:33 AM #1
- Join Date
- Oct 2017
- Posts
- 9
Prints coming out terrible
Any suggestions on what I should do? I have the right size of filament in the slicer.
Thank you NathanIMG_0079.jpgIMG_0080.jpgIMG_0082.jpgIMG_0083.jpg
-
12-12-2017, 09:22 AM #2
- Join Date
- Aug 2015
- Location
- Wisconsin USA
- Posts
- 27
What material and what temp are you using?
-
12-12-2017, 09:27 AM #3
-
12-12-2017, 04:25 PM #4
It looks like the slicer doesn't know the filament and/or nozzle size. You are not getting enough extrusion.
-
12-27-2017, 09:29 AM #5
- Join Date
- Dec 2017
- Location
- North Carolina
- Posts
- 9
Retraction doesn't appear to be working, you have a lot of stringing between moves.
-
12-27-2017, 05:37 PM #6
I know there are better slicers than Cura 15.04.6 but this slicer is simple to setup and use until you learn what setting you need to set.
It can not hurt to try one print.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help