Results 1 to 8 of 8
Thread: ZPrinter 650 - printed nothing
Threaded View
-
11-25-2017, 05:05 AM #5
- Join Date
- Nov 2017
- Posts
- 4
Well, as you wrote the possibilities are more. I think the most likely scenario is a wrong model with some tiny hole(s). We were trying to avoid from thin surfaces and inches too but the printed „thing“ was probably a part of the model. Other models from different programmes printed well. We will print again on Monday so we will see. Thank you for your answer!
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion