Results 1 to 2 of 2
Thread: First 3D printer - around 500$
-
11-20-2017, 11:48 AM #1
- Join Date
- Nov 2017
- Posts
- 1
First 3D printer - around 500$
Hi,
I want to buy my first 3d printer.
The Creality3D CR-10s looks good but I am not sure if I need multiple extruders later. (The "s"-model because of out-of-filament sensor)
1. Is there an other printer around 500$ with two or more extruders?
2. If not: Is there a better printer than the CR-10s for around 500?
Thanks
Michael
-
11-21-2017, 10:17 AM #2
- Join Date
- Nov 2017
- Location
- Alameda, CA
- Posts
- 2
I'm in the same boat as you and was considering the CR-10/CR-10s as well. The Anycubic i3 mega seems to be just as good (arguably slightly better) for a bit less as long as you don't need the larger build volume of the CR-10.
As I mentioned, I'm a total noob shopping for my 1st 3d printer as well so I may not know what the heck I am talking about. lol Just sharing what I have found with my research so far.
Good luck and let me know what you decide on and anything else you find interesting.
Allen
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion