Results 1 to 10 of 15
Threaded View
-
10-15-2017, 01:44 PM #11
Might be but look at all the fun you will miss out on. Plus learning how to solder.
Before you spend the money as a temp test you can jump the fuse to see if the supply still works.
I would disconnect it from the Controller first, just in case.
I would use this fuse. and buy the way Fuses should be way less than $8 each
https://www.ebay.com/p/2pcs-6-3a-Cer...d=151254574054
You could get the fuse at any appliance repair shop
Last edited by Roberts_Clif; 10-15-2017 at 01:51 PM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion