Results 1 to 10 of 474
Threaded View
-
09-27-2017, 02:11 PM #11
- Join Date
- Jul 2017
- Posts
- 193
Re-leveling my bed. Got these numbers:
15:07:54.370 : Z-probe:71.90 X:-66.00 Y:-38.00
15:08:02.066 : Z-probe:71.90 X:66.00 Y:-38.00
15:08:09.656 : Z-probe:71.89 X:0.00 Y:66.00
15:08:12.848 : Z-probe average height:71.90
15:08:12.848 : X:0.00 Y:66.00 Z:40.000 E:0.0000
If I rotate the glass, they change. I am sure the glass is uneven. It also moves a little. Put one of those big paper clip on it to hold it. Need to make a better clamp than I have. Trying another test print.....
Layer height = 0.2
First layer height = 0.3
First layer extrusion width = 100%
If this does not work, I'll just try tape on the heatbed.
:-)Last edited by mjf55; 09-27-2017 at 02:19 PM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion