Results 1 to 10 of 21
Thread: Printbite ... wont bite!
Threaded View
-
08-27-2017, 12:38 PM #8
sounds like your bed levelling is the issue.
You need the nozzle nearer to the bed. You don't need much smoosh - but you do need a little,
NO do not sand it !
Just adjust your printing height for the first layer.
Hang on if it's balling up in the nozzle - then you might need to move the nozzle sightly further away from the bed.
I tend to go in increments of 5 100ths of a mm. so 0.05 at a time either up or down.
Also can't hurt to give it a wipe with some acetone, might have grease on it.
Just hope they haven't changed the formula for this new, thinner stuff and bollixed it up.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion