Results 1 to 2 of 2
-
08-24-2017, 08:58 AM #1
- Join Date
- Aug 2017
- Location
- Sweden
- Posts
- 2
Sailfish update stumble on resetbutton
Hi!
First post here and a cry out for help.
I have a CTC printer with dual extruders. I have been on firmware 1.0. the original until today when i decided to go for a Sailfish update.
I followed this tutorial on YT:https://www.youtube.com/watch?v=Z_Y9tCpsn3Ea , and it works all the way until a shall install FW7.6.
I cant't get the timing right for the resetbutton and download.
Have tried hitting the resettbutton 0.5 seconds before to 2 sec after hitting download.
Do i need to take the Atmegaboard out and program it like an Arduino or what?
Please help, i see a lot of frustation on this matter when i've seached the net , but no solution.
Best regards, Hasse.Last edited by Hasse.69; 08-27-2017 at 02:00 AM.
-
08-24-2017, 02:24 PM #2
- Join Date
- Aug 2017
- Location
- Sweden
- Posts
- 2
Lo and behold after 9!!!!! hours of no go, it works.
A managed to get it to accept the firmware.
After reading this.
"As RepG does a few retries before it timed out again in the log, I just pressed the reset button with a pen tip and it started flashing."
I thought , hey i try to press the resetbutton every 2 sec until the green light start flickering.
So i pressed download, pressed reset,1, 2, 3,4 ,5 , 6 times and then it started to comunicate.
Now i have 2 lines in the LCD and the heatbed is warming up , as expected.
Best regards, Hasse.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help