Heaven help me - I've just bought a delta kit :-)

[curious aardvark]

Osoyoo.com is the dogs bollocks :-)

english touchscreen_640x398.jpg

Right next job - how do i tell the motherboard It's running a delta ?
Plus it looks like it's the screen/card reader that restarts the print after a power cut. Nothing to do with the board :-)
Icon bottom left - the 'continue' button.
To read from a usb stick you just set it to read from usb not sd.
Doesn't automatically switch to whichever is plugged in. But seconds to change over.
Now that is bloody useful !

So all these super expensive 3d printers that are boasting about power cut continuing. It's a £29 screen that's doing it lol

Just had a look and can't see anyway of plugging one of these into Alexa's board. Which is a shame, she'd look good in colour lol

Basically downloaded a file from here: http://osoyoo.com/2016/07/25/mks-tft-2-8-touch-screen/
Unzxipped to sd card. put sdcard into screen, rebooted screen with reboot button. Automatically updated to english firmware.
Took a couple of minutes.

It's got to get more complicated from here.
Also has auto levelling options. Now that would be cool if it just did it without all that buggering about.

So, yep you need one of these.
Also says you can add your own boot up graphics.
I will be playing with that !

Repetier host talks to it :-)
That said I currently have no clue how to get it to change board settings.
Have to read the manual I guess :-)