Heaven help me - I've just bought a delta kit :-)

[curious aardvark]

She's working normally again today. weird.
Those cylinder things.
can do both in 34 minutes if I drop the speed down to 75mm/s and layer height 0.32.

Little one by itself at 0.16 and 75 would be 23 minutes.
big one is an hour.
Or do both together in 1 hour and 5 minutes.

It's because of the individual layer speed and the time s3d allows for cooling. you can adjust those settings in the Cooling tab on the right.
I've currently got it set to allow speed reductions down to 20 %.
If I change that to 50% the one prints in 23 minutes at 75mm/s and 0.16 layer height.

Adjust that upwards until you've got the best quality versus speed setting.

Still not decided how to do the hotplate yet lol

Just bought 10 metres of gt2 belt for £6.69 and some dual purpose drive pulleys and idle pulleys. They were £1 each, threw in some belt tensioners, 20p each
And some 0.5mm brass nozzles for the e3d jhead. and some compression springs, for extruder and bed mounting.

It's just the big stuff and shafts left I think.
Going to be a month or 2 before it all arrives anyway.
up to £109 - still need wheels & shafts, psu and heatpad. Although the psu depends on what heatpad setup I decide on - if I ever decide on one that is :-)