Heaven help me - I've just bought a delta kit :-)

[curious aardvark]

that one is for the 9.5mm .38 cal balls.
As i also have a some 6.35 mm balls I decided I could scale it down and print one for the smaller balls as well.
That will print in under 5 hours for all 4 parts. I'll run that at 0.16 and 150mm/s overnight.

Got about an hour left in the big one :-)

I'll make videos when they're done.

ha ha - works a treat.
At first thought it was random which route (there are 4) the balls went down.
But if you only use one ball - it goes down each route in turn. That's clever !