Results 1 to 10 of 474
Threaded View
-
07-24-2017, 02:00 PM #11
My wire doesn't come out of the y strut.
That the best picture you got ? That could be almost anything, anything at all
Definitely MIB - lmao
Ah ! does it attach to the side strut and point up ?
I can see the value of that. make it a bit smaller and out of stiff black rubber - of which I have an abundance, and we've got something. Black polyflex would also work.
But I haven't tried the rubber on alexa yet :-)
Also not sure if the acorns are better coloured or au natural:
originally I was going to copper coat real acorns for selling as badges. After a number of attempts, came to the conclusion that it would be easier designing and printing an acorn instead.
This wood filament is good stuff, they genuinely look and feel like wood. If I sanded the shine off the back, nobody would know any different - or have the slightest idea how they were made :-)
Oh and it'll stick to cold bed as well :-)
Weirdly the first layer goes down better at 15% than 7%. Still printing at 100mm/s.
I'll try one at .16 and see if it's any difference to the standard 0.2.
Sort out some packaging and should make some money from these. The original model is full acorn, earrings maybe :-)
Now where did I put that copper filament ?Last edited by curious aardvark; 07-24-2017 at 02:17 PM.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion