Results 1 to 10 of 26
Thread: intermittent overextrusion
Threaded View
-
07-22-2017, 04:23 PM #22
- Join Date
- Jul 2017
- Posts
- 42
Great tip about the glass setup. I had some pretty bad PLA deformation on the right side so I printed a dual fan duct right away. Really helped. I'll work on that glass upgrade. I've got a menards and lowes here and even window shops but I haven't ever seeked out glass cut to my specs. Hope one of them will do it for me. Do you think getting tempered glass from one of these places is truly comparable to the borosilicate upgrades sold online?
Since I'm starting to figure out this is more of an issue of hardware instead of software I should also ask about upgrading the hot end. Obviously during searches I am consistently running into the Micro Swiss upgrade. How worth it is it and is there comparable stuff out there or should I go with Micro Swiss?
Design not printing solid
09-17-2024, 06:12 AM in 3D Modeling, Design, Scanners