Results 1 to 10 of 474
Hybrid View
-
06-28-2017, 12:05 PM #1
well you set the middle point as z=0
Long as the bed's flat - you shouldn't need to measure it.
the fan bracket works quite well. currently working on a 2 part duct system.
First part screws into the fan with bog standard pc screws, and comes just below the carriage, the second part will glue to that and be the final nozzle. Just makes it easier to print.
currently test printing part 1.
I actually quite like the free filament.
Nearly used all the blue :-)
**
The slicing algorithms in s3d really need to be looked at.
rectangle. 10 mm wide, 50 long. Has to be roofed
Instead of the first layer of bridging going horizontally, which is an 8mm gap, it did it lengthwise a 50 mm gap - which obviously did not work.
I really need to have another look at cura.Last edited by curious aardvark; 06-28-2017 at 12:16 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help