Results 1 to 10 of 474
Threaded View
-
06-10-2017, 04:37 PM #11
Right, finally got everything back together and we're printing again.
Decided to do the same part at the same settings that I did the first print.
Fingers crossed it comes out the same.
If it does - I can go back a week and start again seeing just how fast she will print :-)
Also see how she works with different slicers and if she will print with polyflex. That will be slow, but might work. Also start costing up a vertical extension.
Also need to try more than one thing at a time, get full plate calibration sorted, sort a print area cooling fan, etc etc :-)
Oh yeah. As the little motor mounting bolts were such a bastard to fit. I ended up using a couple of longish cdrom mounting screws. Fit perfectly and sooo much easier to fit with a long thin crosshead screwdriver.
Right that's looking pretty good.
I need food !Last edited by curious aardvark; 06-10-2017 at 04:56 PM.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)