Results 1 to 10 of 12
Thread: Kapton Oops!
Threaded View
-
06-04-2017, 03:29 PM #9
- Join Date
- Apr 2016
- Posts
- 120
Never had much luck with PVA based glue and ABS, although PLA was always OK.
For ABS, I use PrintTak and some spray adhesive. The combination is enough with my enclosed printer to avoid to much warping and things are so well stuck I need a scraper or sharp knife to lift them!
It's all about the squidge! Get this right and everything else will follow.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion