Results 1 to 10 of 29
Thread: Printing car parts?
Threaded View
-
05-31-2017, 10:51 AM #3
- Join Date
- May 2017
- Posts
- 6
Ok thanks for the reply. So would PC or PEEK be something that is too expensive to use with a 3D printer, in the manner that I'm talking about? Just sort of at the hobbyist level. I understand what you're saying about all those heat cycles.
Also, when you talk about cleavage planes, that reminds me of structural integrity. Are you saying that perhaps the created part, might be weaker than the original part? And not able to stand up to the use that it would see on an automobile? What with all the vibrations, and the weight that may be pressed upon it.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help