Results 1 to 10 of 19
Threaded View
-
05-16-2017, 12:33 PM #14
- Join Date
- Apr 2017
- Posts
- 31
Thanks for the info!
Ok so I have to balance the viscosity and speed of the print. I've been printing with a layer height of 0.2 lately. I'll try 0.3 now.
Also, I have my retraction distance set to 1mm and a speed of 70mm/s. So far so good. No stringing.
Im still having issues with some of the layers. At some point it seems that the extruder is starving. I think its my thermister. I know my thermister is bad and needs to be replaced, because last night while trying to print i started getting a min_temp error while the thermister is connected, which tells me the resistance of the thermister is going infinitely high. I checked the resistance of it while at room temp and it was about 10kohms higher than other two brand new ones i have. So i first have to replace that than try again.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion