After a few emails, I've found out the people I'm working with have found a volunteer from the USA who will assist them with this project. He already uses a "Fusion3 F400" printer (https://www.fusion3design.com/f400-enclosed-3d-printer/). He suggests they buy the same printer, so he will be able to help them set it up and use it. In the future, they may buy additional printer(s) as needed.

Base on what I've posted so far, and the advice I've gotten here, is this likely to be a good choice?

F400-S-with-Yellow-Part-comparison-section-768x576.png.jpg