Results 1 to 10 of 12
Thread: Rounded Overhang
Threaded View
-
03-06-2017, 08:25 AM #3
- Join Date
- Aug 2016
- Location
- Edmonton AB, Canada
- Posts
- 17
Thanks for the reply. I tried lowering the resolution to .1 and used 3 layer shell, made everythign worse. Most of the filament just ended up a stringy mess.
I'm not using supports preferably, as I shouldnt have to, this print doesnt require supports, people use supports and infill like a crutch. I did however make sure infill was high enough to print the top of the head, definiitely needs a dense net for that.
When I printed the one with support, the supports werent even touching the model like the whole time, it was a complete waste of filament. got not time for supports.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion