Results 1 to 10 of 10
Threaded View
-
02-06-2017, 03:58 PM #7
Using slurry helps, it acts like a raft or brim if you use it right. Also you don't have to use the default support settings. Running the supports at 2 angles helps with stability, 45 and -45 is pretty good, or 0 and 90. Usually you can go down to 10-15% fill on supports at 2 angles then run 3-4 layers of dense supports at 60-70% fill.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion