Results 1 to 10 of 29
Threaded View
-
02-05-2017, 11:39 AM #19
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
It is definitely an improvement. Your suggestions along with some input from Micro-Swiss has helped.
I agree on heat. I am now running the bed at 90 to start and dropping to 80 on this run to see how it goes. Also running the fan after a few layers.
Running at 2000mm/min. I think too slow on print speed on the layer and the nozzle has to much time at any one spot.
I haven't tried a thinner layer yet. I am thinking to remove the top to let some heat out. Overall warping is not really an issue not is adhesion.
Thanks for the suggestions.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)