Results 1 to 6 of 6
Thread: E3D best way to change filament?
Threaded View
-
02-02-2017, 09:12 AM #6
As an FYI: When I change filament... I extrude (slowly) until the filament comes out at a uniform rate and appearance. It depends on your printer. But most printers once the filament fills the internal cavity, it will purge the air very quickly. It will go from not extruding consistently to being ready to go in a very short amount of time. Like 2 or 3 seconds of extruding.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion