Results 1 to 10 of 10
Thread: Printer start position
Threaded View
-
01-22-2017, 11:41 AM #6
- Join Date
- Jan 2017
- Posts
- 6
Extrude a line of filament across the front edge of the bed
this part in yours is i think what mine is doing from right to left then it goes in and prints
before it did not extrude till was going in at an angle from left inwards but now like i say it starts extruding filament through as its moving from left to right across very front of table then stops extruding and moves into center to start printing
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion