Results 1 to 10 of 22
Thread: Another total Newbie
Threaded View
-
01-12-2017, 03:29 PM #8
- Join Date
- Apr 2015
- Location
- Northern Ohio
- Posts
- 198
Keep in mind that since you are using ABS super glue is your friend. I did that prototype on the right for my boss over last weekend. I glued the two parts together. As far as print quality goes you are not giving up much. The Qidi tech is an even cheaper option than the flash forgee. I ust like the support and parts from FF. Also there are tons of aftermarket parts for these things. Micro swiss makes an all metal hot end that will allow printing at temps up to 300C for materials like nylon or PC.
woman.jpgdragon.jpgskull.jpgpayment-system.JPGLast edited by Todd-67; 01-12-2017 at 03:43 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion