Is the hairspray just for ABS on glass or do you use it for PLA as well? Is there any reason you couldn't leave it on there permanently instead of cleaning it off?

And while I have you, where did you get your glass and what clips do you use? Still trying to come up with a good solution.

Quote Originally Posted by Todd-67 View Post
I use this on the glass.
http://www.garnierusa.com/products/s...air-spray.aspx
It's non-aerosol, cheap and comes right off the glass with warm water and a little dishwasher soap. Most times I just take the glass out of th printer and let the part cool. You will hear some cracking and popping. Eventually it will come loose on it's own. I have several glass plates lying around that I have prepped for use so I can start another print while one is cooling.