Results 1 to 10 of 63
Thread: Found at the local junk shop
Threaded View
-
01-03-2017, 09:07 AM #32
With vertical slits, better labels and decorative holes:
WithSlits.jpg
There's a tiny crack along the left corner, but no laminations separated. The lettering on the front is a little lost in the waviness. Perhaps I'll just say it's "wibbley wobbley."
WithSlitsB.jpg
The writing on the OUT end came out very clear, but there's a typo! Both output terminals are marked "-". Duh....
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help