Close



Results 1 to 2 of 2
  1. #1

    ThreeUp V3 - New Build - No Z Axis

    I just completed my first build of a ThreeUp V3 Kit and the X and Y axis works just fine, but Z axis does not move. The two NEMA 17 Stepping Drives just oscillate back and forth and make a clicking sound. The wiring diagram for the kit does not match the wiring color sequence. Could this be a bad setting, drive motor, or controller?

  2. #2
    I was able to solve the problem. All of the pinouts were wrong and I had to re-arrange the pin order in the molex connector.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •