Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 10

Threaded View

  1. 11-29-2016, 10:18 PM #8
    TiredJuan
    TiredJuan is offline
    Student
    Join Date
    Dec 2015
    Location
    Seattle
    Posts
    38
    A bit delayed, but I appreciate your response. I've failed to get it working thus far. The motor runs fine, the PTFE tubing has been replaced, the metal parts of the hot end have been swapped/cleaned and replaced multiple times. Even the gear/guide/housing have been swapped from right to left and so on.

    I'm thinking it's something to do with the extruder setup, which is what I believe you're referring to with the screws?

    EDIT: I just ordered an all metal bowden setup. I think it should fix the issue. I hope so.
    Last edited by TiredJuan; 11-29-2016 at 10:27 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules