Results 1 to 5 of 5
Thread: housse
-
11-17-2016, 05:51 AM #1
Last edited by yoda3d; 11-17-2016 at 05:51 AM. Reason: photo
-
11-17-2016, 07:24 AM #2
impressed that the balconies bridge.
did you print it on an sla machine ?
Can't see it being that neat from an fdm.
-
11-17-2016, 11:44 AM #3
I printed it in pla on a simple dagoma discovery200.
As the house in the center is filled, and that there are barriers on the sides,
The balcony is supported during printing
-
11-17-2016, 12:07 PM #4
Yes it looks like you have your printer dialled in well. Are you able to share your printer settings?
Regards,
www.3dexfilament.co.uk
-
11-19-2016, 03:17 AM #5
Hello,yes:
Pla:Polyplus
t°:205°
layer thickness: 0.20mm
Filling: full
Support: NO
time: 5h14min
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help