Results 1 to 10 of 13
Thread: Filaprint bed surface
Threaded View
-
11-07-2016, 06:54 AM #4
You do need a pretty tight calibration with printbite. These days i just adjust it from the z-offset setting in the slicer.
You do seem to use a lot of very high bed temps as well. I pretty much just use 60c for 90% of filaments and 70c for pet-g.
Never needed to go any higher yet.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion