Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Threaded View

  1. 03-21-2014, 10:13 AM #4
    jimc
    jimc is offline
    Engineer
    Join Date
    Oct 2013
    Location
    new jersey
    Posts
    752
    even if its no in the heat too much, pla just starts to degrade right away when its out side. between the UV and the moisture and in this case the salt......pla is not the plastic of choice for this at all. abs or pet would be much better. i did a custom emblem for a hot rod a while back. that was all abs and will be primed and painted
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules