Results 1 to 10 of 42
Thread: Pegasus 12" Build Notes
Threaded View
-
09-21-2016, 05:09 PM #14
- Join Date
- Jul 2016
- Location
- Pennsylvania, USA
- Posts
- 255
Hi
If you are using the correct hardware, your extrusions are not tapped deep enough. You can either have Colin swap them out or get a tap and clean up the parts you have. If you have tapped parts before this one is no different. If you have never done it, spend some time with YouTube. There is a bit of a technique to doing it without breaking the tap.
Bob
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion