Results 1 to 10 of 16
Threaded View
-
08-17-2016, 06:01 AM #11
- Join Date
- Jun 2016
- Posts
- 15
it was fairly cheap. I also found that it "over runs" a couple degrees. For example, my straight up and down is 155 in the servo support in Marlin configuration H. Using prionterface, I select m280 p0 s155 and the servo actually goes beyond like 157-158. If I run the command again, it straightens out to 155. If I repeatedly run the command, it "shakes". So, I was wondering what would be a good servo. I found this one on adafruit. https://www.adafruit.com/products/1143
any thoughts?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help