Results 1 to 9 of 9
Thread: Shifted / Offset layers in print
Threaded View
-
08-01-2016, 05:31 AM #1
Shifted / Offset layers in print
Hi everyone,
I am printing in flexPLA and at some points the 3D printer creates shifts in the layers, only in the X-direction.
See the pic attached for an example.
There can be many causes:
http://reprap.org/wiki/Shifted_layers
The belt tensions are exactly right and the motors work fine.
I suspect a backlash in one of the C-clamps causing at some point too much friction.
Or can it be something simple like the arms needing oil?
Has anyone else had the same problem?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help