Results 1 to 10 of 12
Thread: ABL Home Position Question
Threaded View
-
07-19-2016, 03:38 PM #1
ABL Home Position Question
Hey everyone! After almost a year of having the parts to do so, I've finally followed the ZennmasterM ABL tutorials and have ABL "working"!
For some reason, I can't figure out why my G28 home axes command is putting my hot end in the center front of my bed. Previously, I had my home position set to the rear left corner of the bed out of the way of the print. My concern is that a print will finish and when the printer homes at the end, it will smash into the center of the print.
Has anyone had this problem? Thanks in advance!
gmay3
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion