Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
06-29-2016, 09:53 AM #9
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Filament question: I am going to design and print a bushing for use on my John Deere deck. It is nothing more than a cylinder to go over a post and then an arm goes on that. Just a space filler with minimal movement but can have side loads so crush is a factor (not huge!) and could be exposed to elevated heat levels above ambient air temp. What would you guys recommend I use for a material type? I have PLA & ABS at the moment.
What do you guys think of taulman 618? I came across this: http://www.taulman3d.com/618-features.html
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help